Page 1 of 1
Is it possible to block devices?
Posted: Fri Nov 20, 2015 1:26 am
by MultiKoopa
What I want is for only specific devices, or perhaps even just one specific device, to be able to connect to my computer running UMS.
Is there some way to do this through the program?
Or some way at all?
Re: Is it possible to block devices?
Posted: Fri Nov 20, 2015 1:38 am
by Nadahar
Yes, per IP address.
In the GUI, if you go to the "General Configuration" tab, under "Network Settings" you will find "Use an IP filter (whitelist)". Anter IP addresses you want to be able to reach UMS here, comma separated.
You can also create a file "UMS.deny" in your profile folder (the same folder where UMS.conf is placed, normally C:\ProgramData\UMS on Windows) where you can blacklist addresses.
Re: Is it possible to block devices?
Posted: Fri Nov 20, 2015 8:22 am
by MultiKoopa
perfect. Thank you!
Re: Is it possible to block devices?
Posted: Sun Mar 13, 2016 12:12 pm
by HT1
in UMS.deny will this work ?
192.168.2.70
or do i have to type something else. i just want the whole thing blocked to that ip , not just a folder.
Re: Is it possible to block devices?
Posted: Mon Mar 14, 2016 2:11 am
by Wolfgan
Re: Is it possible to block devices?
Posted: Mon Mar 14, 2016 9:27 am
by HT1
so basically to block a device from accessing ums it isn't ums.deny but the ip-filter list in ums.conf thanks to infidel.
look here people :
https://github.com/UniversalMediaServer ... #ip-filter