Page 1 of 1
UMS wont connect while using PIA
Posted: Thu Jul 28, 2016 11:28 am
by Knowl3dge
SO THIS IS AN OFF AND ON ISSUE!!!
I have installed PIA and now UMS has connection issues with my Samsung television. It was working fine up until the latest update. In the past I have uninstalled PIA and reinstalled and everything works fine. It seems that there should be something I can do to make both work together but I'm at a loss.
Re: UMS wont connect while using PIA
Posted: Fri Jul 29, 2016 10:57 am
by BlearySteve
Did anyone ever get back to you about this.
Re: UMS wont connect while using PIA
Posted: Fri Jul 29, 2016 1:33 pm
by SubJunk
What's PIA?
Re: UMS wont connect while using PIA
Posted: Sat Jul 30, 2016 3:42 am
by squadjot
I think it stands for Private Internet Access / VPN
Re: UMS wont connect while using PIA
Posted: Sat Jul 30, 2016 6:00 am
by BlearySteve
For me they where working together fine until about 3 days ago.
Re: UMS wont connect while using PIA
Posted: Sat Jul 30, 2016 1:45 pm
by Darth Ed
Try this:
Go to the "General Configuration" tab and locate the "Force networking on interface:" setting under the "Network settings (advanced)" section. Change that setting to "en0 (your LAN IP address)". Then quit and re-launch. If that doesn't work, keep trying any of the settings listed there besides "en0".
Re: UMS wont connect while using PIA
Posted: Sun Jul 31, 2016 4:21 pm
by BlearySteve
Don't have a selection for eno but I tried whatever was there and nothing worked.